![]() Persist Remote IP: Do no change remote IP settings if the connection restarts.Persist Local IP: Do not change local IP settings if the connection restarts.Persist Key: Don't re-read key files if the connection restarts.Persist Tun: Do not reset the network adapter if the connection restarts.The following persist options are only effected if the connection or OpenVPN restart without Viscosity disconnecting the connection. Please see this article for more information if you are having issues with ping-restarts. Ping Restart: Restarts the connection if no traffic or pings have passed in x seconds.Ping: Pings the remote host every x seconds to maintain a connection.A TLS ( Tls-Auth) key can also be optionally used for an additional layer of authentication. It uses at minimum a server ( CA) and user ( Cert) certificate and a user key ( Key) for authentication. This is the most common form of authentication for OpenVPN. Use Username/Password authentication: Check this if the server you are connecting to requires a username and password.Type: The type of authentication setup to use for this connection, these are described more in depth below.The following are common options to all authentication types: Connect when Viscosity opens: This option is available on all tabs and will cause this connection to begin connecting as soon as Viscosity is launched.Automatically reconnect if disconnected: When enabled Viscosity will automatically try to reconnect the VPN connection if it becomes disconnected due to a dropout or server interruption.Enable IPv6: Enabling this option allows IPv6 to be setup for the connection.Enable DHCP: This enables support for IP assignment via DHCP for "tap" connections.Device: The type of network interface to use, which is either "tun" (Layer 3 routed networking) or "tap" (Layer 2 bridged networking).Protocol: The protocol type (UDP or TCP), and IP version (Automatic, IPv4, or IPv6) for the connection.Port: The port for the server you are connecting too.If entering multiple servers that use a different transport protocol (udp/tcp) or port number, they can be entered using the syntax "::", for example "1.2.3.4:1194:udp" and ":1195:tcp". Multiple servers can be entered separated by a comma. Address: The address for the server you are connecting too.This is your reference for how to identify the connection later.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |